 |
|
 |
9301/9302 - 1 & 2 Channel Synthesized Function/Arbitrary Waveform
|
| " |
Log, linear, phase continuous sweeps |
| " |
Frequency to 31MHz |
| " |
0.01?Hz frequency resolution |
| " |
16 to 16K points arbitrary waveform lengths |
| " |
Standard waveforms: Sine, Square, Triangle, Ramp and Noise |
| " |
Includes waveform design software |
| " |
Waveforms may be designed via front panel or software |
| " |
Dual independent channels (9302) |
| " |
Sweep times to 1000s |
| " |
AM, FM and phase modulation |
| " |
RS-232 and software interface |
|
Specification |
|
|
|
| Waveforms |
Sine, Square, Triangle, Ramp Noise, Abitrary | |
|
|
|
| Sine |
0.01?Hz to 31MHz |
| Square |
0.01?Hz to 12MHz |
| Ramp and Triangle |
0.01?Hz to 2MHz |
| Noise |
10MHz | |
|
|
|
| Output |
9301: 1CH
9302: 2CH |
| Output Volts |
20mV to 20V P-P, no load 10mV to 10V P-P, into 50W |
| Resolution |
3 digits |
| Best Accuracy |
Sine wave: ?0.2dB (1?Hz to 20MHz)
Square Wave: ?3% (0.01?Hz to 100KHz)
Ramp, Triangle and Arbitrary: ?3% | |
|
|
|
| Offset |
0 to ?10V (no load)
0 to ?5V DC (50W load) |
| Resolution |
3 digits |
| Accuracy |
?1.5% + 0.2mVDC | |
|
|
|
| Sine Wave Spectral Purity Spurious |
< -50dBc (non harmonic) |
| Phase Noise |
< -50dBc in a 30KHz band |
| Subharmonics |
< -50dBc |
| Harmonic Distortion |
-45dBc: DC to 1MHz
-32dBc: 1KHz to 31MHz | |
|
|
|
| Rise/Fall Time |
< 15ns from 10 to 90% of full amplitude |
| Asymmetry |
< 1% of period + 4ns |
| Overshoot |
< 5% | |
|
| Ramp, Triangle and Arbitrary | |
| Rise and Fall Time |
<35ns |
| Settling Time |
<1?s |
| Linearity |
?0.5% FS | |
|
|
|
| Standard |
Sine, Square, Triangle, Ramp, DC, Exponential Fall, Noise, Freehand, Line, Damped Sine |
| Sample Rate |
40MS/s (Max) |
| Waveform Length |
16 to 16,384 points |
| Amplitude Resolution |
12 Bit | |
|
|
|
| Range |
9999.99? |
| Resolution |
0.01? |
| Rate |
0.001Hz to 10KHz | |
|
|
|
| Source |
Internal |
| Waveforms |
Sine, Square, Ramp, Triangle, Ramp, Arbitrary |
| Rate |
0.001Hz to 10KHz |
| Span |
0.01Hz to 31MHz (2MHz for Triangle or Ramp) | |
|
|
|
| Source |
Internal or external |
| Waveforms |
Sine, Square, Ramp, Triangle, Arbitrary |
| Depth |
0 to 100% |
| Rate |
Internal: 0.001Hz to 10KHz; External: 20KHz Max. |
| Distortion |
< -35dB |
| DSB Carrier |
< -35dB typical at 1KHz modulation rate |
| Ext. Input |
5V for 100% modulation | |
|
|
|
| Type |
Linear or log, phase continuous |
| Waveforms |
Up, down, Up-down, Single sweep |
| Sweep Time |
100?s to 1000s (0.001Hz to 10KHz) |
| Span |
0.01?Hz to 31 MHz (2MHz for Ramp and Triangle) |
| Markers |
Two markers may be set between any sweep point. Sweep Output - 0 to 10V linear ramp signal synchronized to sweep. | |
|
|
|
| Waveforms |
Sine, Square, Triangle, Ramp, Arbitrary |
| Frequency |
2MHz Max for any waveform |
| Count |
1 to 65,000 cycles/burst |
| Phase Shift |
?100KHz | |
|
|
|
| Source |
CH 1: Single, Int rate, Pos Ext, Neg Ext 1, Line
CH 2: Int CH 1, Int rate, Pos Ext 2, Neg Ext 2 (9302 only) |
| Rate |
100?s to 999.99s |
| External |
Positive or negative slope, TTL input |
| Output |
TTL Level | |
|
|
|
| Accuracy |
?3 PPM (20 to 30?C) |
| Aging |
?3 PPM/Yr |
| Input |
10MHz/N ?2 PPM where N=1 to 8.1V P-P Min input level |
| Output |
> 1V P-P 10MHz sine wave into 50W | |
|
|
|
| Interface |
RS-232 (baud rates from 2400 to 19.2k bps, DCE) |
| Size |
14.0" W ? 3.5" H ? 13.5" D |
| Weight |
22 lbs |
| Power Consumption |
46W (9301); 80W (9302) |
| Supplied Accessories |
Manual, Line cord, Software, BNC cable | | |
|
|
|
To request more information, please fill the form below.
|
|
|
|
ITS Instruments
Under Construction..
Click here to continue.
|
